Caution, Fig 4.1 4 detail 2, Adjusting the tilt angle of the flat panel screen – Peerless-AV ST24D - Installation User Manual

Page 9: Fig 4.2 detail 3

9 of 9

ISSUED: 09-15-05 SHEET #: 202-9032-4 10-04-11

Adjust tension knob on right side of mount shown
in detail 2 to desired tension to balance your
screen size and weight.

Push or pull from top or bottom of screen to adjust
tilt as shown in figure 4.1. The tilt can be adjusted
to a maximum of 15° forward or 5° backward.

Note: To lock the screen into the desired tilt
position, tighten tension screws on both sides of
mount shown in figure 4.2 and detail 3 using
wrench (FF).

fig 4.1

DETAIL 2

TENSION
SCREW

Adjusting the Tilt Angle of the Flat Panel Screen

• Be careful not to pinch fingers when pushing screen

from the bottom.

CAUTION

• Do not tighten screws with excessive force.

Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.

CAUTION

TENSION
KNOB

fig 4.2

DETAIL 3

SmartMount is a trademark and Peerless is a registered trademark of Peerless Industries, Inc.

All other brand and product names are trademarks or registered trademarks of their respective owners.