H n m, Lo r, Back view – Peerless-AV CM850 - Installation User Manual

Page 15

15 of 48

ISSUED: 07-22-08 SHEET #: 120-9055-7 (2013-10-01)

Visit the Peerless Web Site at www.peerless-av.com

For customer care call 1-800-865-2112

Slide one mesh sleeve (R) over each cable. Use
cable ties (O) to tighten both ends of mesh sleeves
to cables.

NOTE: Loop cable ties through cable mounts and
tighten cable and mesh sleeve to cable mounts.

Roll can be adjusted 1° clockwise or
counterclockwise.

To adjust roll, loosen M10 x 15 mm screws (I)
slightly, leaving them snug. Level display and
adapter brackets, then tighten screws (I) .

NOTE: When adjusting roll, screws should be
retightened as indicated in step 8.

Optional: To lock one sliding arm of mount in place,
slide locking tab (H) over top or bottom of sliding
arm and attach to mount using one M5 x 10 mm
screw (M) and one spacer (N).

NOTE: Full assembly/display not shown for clarity.

SLIDING ARM

H
N

M10 x 15 MM SCREW (I)

Optional: To lock mount in closed position, insert
one M5 x 40 mm screw (L) into tapped hole in either
top or bottom of fl at plate.

NOTE: Full assembly/display not shown for clarity.

FLAT
PLATE

TAPPED HOLE

NOTE: MOUNTING PLATE SHOW

WITHOUT FULL WALL MOUNT
ASSEMBLY FOR CLARITY.

BACK VIEW

CABLE
MOUNTS