Peerless-AV CM850 - Installation - Manual (Page 10)

10 of 48 ISSUED: 07-22-08 SHEET #: 120-9055-7 (2013-10-01)
Visit the Peerless Web Site at www.peerless-av.com For customer care call 1-800-865-2112
Attach and tighten two support brackets (C) to inside of interface plate (A) and wall plate (B) using two sets of
1/4-20 x 1" round phillips head screws (U), 1/4" fl at washers (X) and 1/4-20 fl anged serrated locknuts (V). Repeate
for remaining interface plate then tighten all fasteners.
NOTE: Support bracket fl anges must face inward as shown. 4
Align wall mount assembly (G) with interface
plates (A) to determine location of cage nuts
(W) used to secure wall mount assembly (G) to
interface plates. Install cage nuts from rear side of
interface plates (A) as shown in fi gure 5.1.
fig 5.1
fig 5.2
U
X
V
V
X
U
B
A
W
FLANGE (C) FACES DOWN
SLOT FACES
WALL PLATE
FLANGE (C) FACES UP
Attach wall mount assembly (G) to interface plates
(A) using eight 1/4-20 x 1" round phillips head
screws (U) and 1/4" fl at washers (X) through slots
into cage nuts as shown in fi gure 5.2. 5-1 5-2
U
X
G
A
MOUNTING SURFACE
NOT SHOWN FOR
CLARITY