Peerless-AV FPE42F-S - Installation - Manual (Page 10)

10 of 16 ISSUED: 07-16-10 SHEET #: 061-9050-7 08-07-12
Reinstalling Bay Door
If bay door was removed in step 1, lower bay door
onto enclosure assembly and slide to the left to
engage hinges. Align holes of center hinge with
holes of enclosure assembly ( A). Reinstall two
10-24 x .5" phillips screws to inside of enclosure
assembly as shown in figure 5.1.
5
• Grasp bay door firmly. Bay door will swing freely when gas springs are removed.
Secure both gas springs to bay door by pressing
firmly as shown in detail 4.
NotE: Be sure thin end of gas spring is
attached to main enclosure assembly.
DEtAIL 4
5-1
WARNING
GAS SPRING
BAy DooR
MAIN ENCLoSURE
ASSEMBLy
fig. 5.1
10-24 x .5"
PHILLIPS
SCREWS
A