Fi g 11.2, Fi g 11.1 – Peerless-AV SC590 - Installation User Manual

Page 10

10 of 12

ISSUED: 08-08-12 SHEET #: 009-9074-1

Begin with the shortest length screw, hand thread through multi-washer and adapter bracket (F) into display as
shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not
over tighten. If screw cannot make three full turns into the display, select a longer length screw from the baffl ed
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.

NOTE: Spacers may not be used, depending upon the type of display.

Begin with longer length screw, hand thread through multi-washer, adapter bracket (F) and spacer in that order
into display as shown below. Screw must make at least three full turns into the mounting hole and fi t snug into
place. Do not over tighten. If screw cannot make three full turns into the display, select a longer length screw from
the baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.

For Flat Back Display

For Bump-out or Recessed Back Display

11-2

11-1

If you have any questions, please call Peerless customer care at 1-800-865-2112.

fi g 11.2

SCREW

MULTI-WASHER

ADAPTER BRACKET (F)

DISPLAY

SPACER

fi g 11.1

SCREW

MULTI-WASHER

ADAPTER BRACKET (F)

DISPLAY