Warning, Installing adapter brackets to flat panel display – Peerless-AV SC560FK - Installation User Manual

Page 8

8 of 11

ISSUED: 09-30-11 SHEET #: 009-9057-3 05-23-12

NOTE: "X" dimensions should be equal.

Installing Adapter Brackets to Flat Panel Display

To prevent scratching the display, set a cloth on a fl at, level surface that will support the weight of the display. Place
display face side down. Refer to display manufacturers instructions or customer service, for removing any knobs,
base, cover, or screw(s) on the back of the display to prepare mounting. These need to be removed to allow the
adapter brackets (F) to be attached. Select the small, medium, large or extra large screws from the baffl ed fastener
pack then attach adapter brackets to display following fi gure 10.1 or 10.2.

NOTE: Top and bottom mounting holes must be used for attaching adapter brackets. Verify that all holes are
properly aligned, and then tighten screws using 4 mm security allen wrench (AA).

CENTER BRACKETS

VERTICALLY ON BACK

OF DISPLAY

Notes:

• The number of fasteners used will vary,

depending upon the type of display.

• Multi-washers and spacers may not be

used, depending upon the type of display.

• Use the corresponding hole in the multi-

washer that matches your screw size as
shown.

MEDIUM HOLE FOR M5 SCREWS

SMALL HOLE FOR M4 SCREWS

LARGE HOLE FOR M6 SCREWS

MULTI-WASHER

NOTE: For fl at back displays proceed to step

-1. For bump-out or recessed back display skip to step

-2

• Tighten screws so adapter brackets are fi rmly attached. Do not tighten with excessive force. Overtightening can

cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become
detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.

• If screws don't get three complete turns in the display inserts or if screws bottom out and adapter brackets are still

not tightly secured, damage may oXur to display or product may fail.

WARNING