Peerless-AV DS-VW765-LAND - Installation - Manual (Page 7)

7 of 13 ISSUED: 2013-05-13 SHEET #: 145-9011-9 2013-06-25
B
B
3
SECURITY SCREW
Attach adapter brackets ( B) to pull-out mount assembly. Slide adapter brackets (B) into position.
Loosely fasten in place using security screw as shown in detail 1.
NOTE: Once display is located in desired position ( ± 2" from center), tighten security screws using
4mm allen wrench ( K) to lock in place.
Attaching Adapter Brackets to Pull-Out Mount Assembly
DETAIL 1
NOTE: Make sure to use largest hole pattern on back of display.
Attach adapter brackets ( B) to back of display using four M6 x 12 mm socket pin screws (I) with nylon shoulder
washer ( H), or four M8 x 15 mm socket pin screws (J) as shown below.
B
H
I or J
2
400 mm 300 mm 200 mm PLP
MAX VESA-700 mm
MIN VESA-200 mm
Attaching Adapter Brackets to Display
DISPLAY
PULL-OUT MOUNT ASSEMBLY