Peerless-AV PSM-UNV-W - Installation - Manual (Page 7)

ISSUED: 08-09-06 SHEET #: 055-9469-3 06-15-10
Visit the Peerless Web Site at www.peerlessmounts.com
7 of 9
For customer care call 1-800-729-0307 or 708-865-8870.
Flip projector upside down. Attach lower tray to
the bottom of the projector using appropriate
number of screws (H,I,J,K,L,M,N,O,P),
washers (F) and spacers (C) as shown. Use
4 mm allen wrench (R) to tighten
screws (H,I,J,K,L,M,N,O,P).
Important: If projector does not have at least
three mounting holes, do not use this adapter
plate.
NOTE: Some projectors have feet which can be
removed and the corresponding threaded insert
can be used for a mounting hole.
NOTE: Projector may differ slightly in appearance.
Installation of Projector
PROJECT
OR
LOWER TRAY
4
F
C
SCREW
• Do not overtighten! Overtightening may cause
permanent damage to the projector. Torque to
26-35 in • lb (30-40 kg • cm).
WARNING
3A
Extension Column Installation (Sold Separately)
Thread tray assembly (A) into cord management (B) to extension column (sold separately) as shown.
NOTE: Slotted set screw (X) is used to jam against threads of extension column to prevent any excess
movement of projector mount assembly (A).
Skip to step 4
A
B
• Do not overtighten! Overtightening may cause
permanent damage to the projector. Torque to
26-35 in • lb (30-40 kg • cm).
WARNING
1 1/2" EXTENSION COLUMN
(SOLD SEPARATELY)
UL LISTED EXT OR ADJ
SERIES)