Peerless-AV FPEPM-08 - Installation - Manual (Page 2)

2 of 24 ISSUED: 11-10-10 SHEET #: 061-9060-1
Table of Contents
Parts List.................................................................................................................................................................................3
Installation to Solid Concrete Surface ....................................................................................................................................4
Installing Tilt Plate...................................................................................................................................................................6
Mounting Main Enclosure Assembly.......................................................................................................................................7
Tools Needed for Assembly
• 3/16" allen wrench, 6mm allen wrench, 1/2" socket wrench
• drill
• 3/8" (10mm) drill bit
• level
NOTE: Read entire instruction sheet before you start installation and assembly.
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, for US
customers please call Peerless customer care at 1-800-865-2112, for all international customers, please contact
your local distributor.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Due to outdoor environmental conditions such as strong wind gusts, heavy snow, hail, rain, etc. The environmental
enclosure, together with its mount, extension tube and hardware, must be inspected at least once a year, and
immediately following any time winds exceed 90 mph. A qualifi ed installer or inspector must check for signs of rust,
loose fasteners, bent metal, etc. If evidence of excessive wear, deterioration or any unsafe condition is observed,
this product must be taken out of service immediately. Direct all inquiries to customer care if you have any
questions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components.
• Never exceed the Maximum Load Capacity. See page one.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws fi rmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power.
• This product was designed for use with Peerless Protective Enclosures only.
• This product was designed to be installed on the following fl oor construction only;
FLOOR CONSTRUCTION HARDWARE REQUIRED
• Solid Concrete Included
• Other or unsure? Contact Qualifi ed Professional
WARNING