PowerWalker VFI 1000RM LCD User Manual

Page 8

2.4 Battery replacement
NOTICE: This UPS is equipped with internal batteries and user can replace the batteries

without shutting down the UPS or connected loads.(hot-swappable battery design)

Replacement is a safe procedure, isolated from electrical hazards.

CAUTION!! Consider all warnings, cautions, and notes before replacing batteries.

Note: Upon battery disconnection, equipment is not protected from power outages.

Step 1

Step 2

Step 3

Remove front panel.

Disconnect battery wires.

Pull out the battery box by
removing two screws on the front
panel.

Step 4

Step 5

Step 7

Remove the top cover of battery
box and replace the inside
batteries.

After replacing the batteries, put
the battery box back to original
location and screw it tightly.

Re-connect the battery wires.