Pace-Edwards BL Honda Ridgeline - Manual (Page 6)

BEDLOCKER ® RIDGELINE 6
C.
STEP 8: INSTALLING DRAIN TUBES
The Ridgeline has standard OE plastic/rubber access ports in the
fl oor at the front of the truck bed. You will need to use the box knife
to remove these plugs. (Figure 7a)
Once removed use a suitable drill bit (such as a taper drill or step
drill) and drill or create drain tube clearance holes at 3/4” (19mm)
through the removed plugs. (Figure 7b)
Ensure that the foam washer is in place on the drain tube end
being inserted into the bottom of the canister (This will prevent
water leakage).
Test fi t the drain tube to determine the length you want to trim it.
Always caution on the long side.
With the cover opened, insert the drain tube fi ttings into the pre-
drilled holes on the underside of the canister by fi rmly pushing
them in place from under the canister. Drain tube should click into
place. (This is a tight fi t that may require much pressure and a
slight turning of the tube as it is being pushed in.)
Place the other end of the drain tube through the front access drain
port plug.
FOAM WASHER
DRAIN TUBE FITTING
FRONT ACCESS
DRAIN PORT PLUG
DRILL HOLE
IN DRAIN
PORT PLUG
FIG.7a
FIG.7b
The electronics box has been pre-mounted to the inside of the canister.
Connect the battery wire harness into the 2-wire plug at the end of the canister (also
connect the optional manual switch harness, if installed at this time)
Attach the Red (positive) and Black (negative) wires to the battery or the truck manufacturers
suggested connection points at this time.
Unit is now ready to operate.
Press the Open button to open cover and press the Close button to shut the cover.
STEP 7: CONNECTING THE ELECTRONICS
HARDWARE USED:
Locate the sweep seals (rubber weather strips) on the rails.
Apply Pace Edwards’ UV Protectant (or 303 brand protectant)
to a rag and wipe the underside of the sweep seal and the top
of the wear strip.
Extend the cover to the tailgate. Use an Allen wrench if
needed to carefully draw out the sweep seal (seal should be
angled outwards toward the cover – not rolled in toward the
bed rail). (Fig. 6A)
Proper care and placement of the sweep seal will ensure
smooth operation of the cover. Alcohol, petroleum based or
silicon-based cleaners such as Armor-All
® should be avoided
and ARE NOT recommended for our covers
STEP 6: LUBRICATING & PLACING THE SWEEP SEALS
RIBBED BLANKET
SWEEP SEAL
WEAR STRIP
RAIL
FIG.6A
2-BUTTON REMOTE
KEY FOB x 2