American Car Craft Corvette Side Pipes "Lake Pipes Show Exhaust only Polished 2005-2013 C6" - Manual (Page 2)

2. Use cut-off wheel to remove marked area for bracket placement.
3. Clean frame with rubbing alcohol and check with masking tape, to make sure it is tacky.
4. Apply adhesive promoter to frame, where bracket will be attached.
5. Peel Red backing from 3M adhesive on rear bracket and stick to frame.
6. Drill (2) 3/16” holes through bracket into frame and install both lag bolts.
7. Drill 9/64” pilot hole for body screw and install body screw with flat nut.
Front Bracket Installation:
1. Front bracket placement should be up against the front inner fender liner, allowing adequate clearance for jack
port. Make sure the bracket bend is right at the edge of the fiberglass rocker.
2. Clean frame with rubbing alcohol and check with masking tape, to make sure it is tacky.