American Car Craft Corvette Exhaust Filler Panel Corsa 4.0 Quad Tips Laser Mesh Polished 2005-2013 C6 - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
C6 4’’ CORSA EXHAUST PORT FILLER PANEL LASER MESH
PART # 042015
patent pending
Parts Included: Items Needed:
___ Filler Panel Household Isopropyl Alcohol
___ 1-Adhesive Promoter Pack Philips screwdriver
___ 2-1’’ #8 Washer Head Screws
__2-#8 Pan Head Screws
___ 2-Flat Nuts
YOUR PANEL COMES TO YOU WITH A PROTECTIVE LINER. DO NOT
REMOVE THIS LINER UNTIL INSTALLATION IS COMPLETE!
1. Clean the entire underside of the factory bumper cover to the left and right of the
exhaust first with soap and water then with household isopropyl alcohol.
2. Wipe the area with the adhesive promoter (provided). This will insure a strong
bond.
3. Pre-fit your new filler panel by slightly nudging the muffler tips until they are
able to slide thru the filler panel. Slide the panel back and check the fit making
sure the back underside slides up behind the bumper and also that it fits snug
above the exhaust tips to the urethane bumper. IMPORTANT TECH TIP: During
this product development and after performing many installations we have noticed
that there can be a variable from car to car of the exhaust tip position by as much
as a half an inch up or down and sometimes from side to side. Due to this fact, on
occasion, it may be necessary to adjust the tips and or the new panel in order for
them to be able to receive each other. The most common situation is that the