American Car Craft Corvette Side Pipes "Lake Pipes Show Exhaust only Polished 2005-2013 C6" User Manual
American car craft instructions
AMERICAN CAR CRAFT INSTRUCTIONS
C6 Corvette “Lake Pipes” Show Only - Polished
PART #042120
PARTS INCLUDED:
2-Polished Stainless Steel Lake Pipes
4-Formed Stainless Steel Mounting Brackets w/ Attachment Tape
8-3/8” Lag Bolts
4-#8 Washer Head Screws
4-Flat Nuts
12-#8 Black Washer Head Screws
1-9/64” Cobalt Drill Bit
2-Adhesive Promoter Packets
INTORDUCTION: These written instructions are intended to complement the installation video provided and available
on our web-site. Your C6 Corvette “Lake Pipe” Show Kit will come to you with everything you need for proper and safe
installation. American Car Craft has provided a safe and tested installation process, but cannot guarantee installation by
an outside company or person. As long as the directions provided are followed correctly, you will have years of
enjoyment with your new C6 Corvette “Lake Pipes.
Rear Bracket Installation:
1. Mark rear bracket location, for trimming body panel. Placement should allow adequate clearance for jack port.
Make sure the bracket bend is right at the edge of the fiberglass rocker.