American Car Craft HHR Wiper Cowl Polished 2006-2012 - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
HHR POLISHED WIPER COWL COVER
PART#423009
PARTS INCLUDED:
___1-Stainless Wiper Cowl Cover
___4-Zip Ties
___1-Adhesive Promoter Pack
You new cover comes to you with a clear protective liner. Do not remove liner until
instructed.
Your new insert will set directly into the outlined curved section of the factory wiper cowl.
1. Remove the five harness retainers protruding through the top and face of the factory
wiper cowl. Reattach this harness along the back of the engine to the other harness
there with the four zip ties provided.
2. Scrub the top of the factory cowl with alcohol to remove dirt. Then swipe the area
with the adhesive promoter provided. Before permanently installing, place the insert
into position to check the fit and also to get acquainted with just how it will set in place.
Once you have got a good idea about how you will set the insert simply remove the red
release liner from the back of the cover and set in place. Press firmly along its length to
set. Remove the protective liner.