American Car Craft Camaro Inner Fender Covers Polished Deluxe 10Pc w_Fuse Box Cover 2010-2011 User Manual

Page 3

2. Once the two screws have been installed mark the clip location of the back of the panel to the wiper cowl. You have
been provided with two small strips of black furry tape. This tape has been supplied to be placed at the contact point of
the panel to protect the wiper cowl from damage. Remove the panel and then swipe the spot with the adhesive
promoter provided. Apply the tape allowing it to roll over the front of the cowl ridge to the underside and then press
firmly to set it. Reinstall the new cover and peel the protective liner at both screw locations and then reinstall the two
screws and press on the 1''chrome screw covers provided. Perform this same procedure for the opposite side and then
remove the protective liner from both fender covers.

3. You have been provided with a chrome decorative positive terminal cover. This cover will just set over the red factory
terminal cover.

4. The last thing to do will be to set the fuse box cover plate into position over the box to determine its position. Before
you permanently stick the panel in place hold it to the fuse box cover and release the cover from the fuse panel opening
it and closing it to make sure the new cover sits back far enough to allow you to operate the door without binding on the
new fender cover and or the new radiator support cover if you are planning to install one. Once you have a good idea
about how it will sit scrub the top of the factory cover with alcohol and then swipe the cover with the adhesive
promoter provided. Allow a few seconds to dry and then peel the red release liner from the attachment tape on the
back of the new cover and carefully set it into the correct position pressing firmly to set.

Remove the protective liner to finish the installation.

American Car Craft LLC

18924 Sakera Rd Hudson, FL. 34667

Ph 727.861.1500 Fax 727.861.1520