American Car Craft Camaro Inner Fender Covers Polished Deluxe 10Pc w_Fuse Box Cover 2010-2011 - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
POLISHED CAMARO 10PC FENDER COVERS w/ FUSE BOX COVER
PART #103025
PARTS INCLUDED:
2-Stainless Inner Fender Covers
1-8pc Shock Tower Covers (see below)
1-Fuse Box Cover
1-Battery Terminal Cap
4-10/32 Pan Head Screw Inserts
4-1” Chrome Press on Screw Covers w/Butyl
4-1/8” Fender Washers
4-Thick Flat Washers
4-6mm Threaded Replacement Bolts
2-Small Strips of Black Furry Tape
2-Adhesive Promoter Packs
Introduction: Your new covers are designed to fit into the factory wiper cowl and set in place over the shock towers.
The new covers have also been designed to attach directly at the factory fender bolt location using our patented
replacement bolt mounting kit.
Liner Information: Your new accessories will come to you with a protective surface liner. Leave this liner in place until
the installation is complete to prevent finger prints and or possible scratches during installation.
Step 1 is to install the:
CAMARO 6pc Shock Tower Covers
PART#103026
PARTS INCLUDED:
2-
pieces of 1/4 molding 16’’
2-Stainless Self Stick Ring Plates
2- 3/4” Caps
2-Stainless Cone Covers