American Car Craft Corvette Inner Fender Covers Polished 4Pc 2005-2013 C6+GS - Manual (Page 2)

2. Slide the backside of your new passenger cover under the gasket ridge and down
over the fuse relay box. Be careful not to catch the engines dipstick.
3. You will notice a small notch at the pointed side of your new cover. This notch is
designed to hook into the radiator shroud. This can be achieved by pulling the
shroud forward, which will create clearance for the notch to engage. It will hook
to the side of the radiator shroud. Then gently position the point of the new cover
down slightly to lock in place.
4. You have been provided with a long black sheet metal screw and a 9/64
th
cobalt
drill bit. Locate the small tab at the rear of your new cover and pull it up to the
gasket ridge and hold firmly. Make note of the covers position around the fuse
box and adjust so that there is an even amount of space all around it. Once you are
satisfied with its position drill a small hole thru the gasket ridge directly into the
new covers tab area. Be sure to hold in position firmly. Once this is complete
blow off any metal shavings. BE CAREFUL THESE CAN SCRATCH YOUR
NEW COVER.
5. Carefully remove protective liner. Once the panel has been uncovered simply
insert the long black washer head screw thru the hole you’ve created in the gasket
ridge and into the cover. Be careful not to over tighten.
6. (Fuse box relay cover) You will notice a large tab on the side of this small cover.
Test fit the cover so that the tab fits thru the notch in the large cover, so that the
cover has about a 1/16
th”
gap at the right side of the tab and left side of the cover.
Holding it in position unlatch the factory lid and test its motion opening and
closing. Adjust position of this cover so that it opens and closes freely and make
note of the position. Once you are satisfied remove the new cover then remove the
red liner from the attachment tape on the underside of the cover and reposition
and press firmly to set. You should be able to latch open and close and re-latch
without obstruction. Note: This is a permanent installation! When it comes time to
remove your large cover simply unsnap the factory fuse box cover with the small
cover attached to allow removal of the large cover.
7. Your driver’s side cover can be installed in exactly the same way as the
passengers cover (see steps 1-5) only you must remove all fill caps.
8. Once your cover is in place replace all fill caps. Then remove the protective liner.
Replace your wiper cowl gasket. You have been provided with two large Velcro