American Car Craft Dodge Charger _ Chrysler 300 5.7L Plenum Cover Perforated 2011-2013 User Manual
Page 5
5
11. Finally the next step will be to set the new plenum cover. You will notice that the new cover has four small
Velcro attachment cookies attached to the underside flat rails on both sides. Remove the 8 halves from the
cover and set the new cover directly to the installed fuel rail covers. At this point you will need to tweak the
shape of the plenum cover so that the rear end aligns with the top edge of the fuel rail covers and the front end
sits as low as possible to the throttle body. This is very important in order to maintain adequate clearance
between the new plenum cover and hood liner. Ideally it should rest directly on top of the throttle body. This
can be achieved by simply forming the cover by hand until it rests in place in this way. Once you have tweaked
the shape like this, mark the angle of the plenum covers position to the fuel rail covers using a length of masking
tape. Also mark each of the 8 locations of the Velcro attachment cookies attached to the plenum cover to the
tape. Then remove the cover and swipe the fuel rails with the adhesive promoter at the 8 locations. Then set the
(8) Velcro cookie half’s removed earlier and set them beneath the tape line in the positions marked. Then
remove the protective liner and set the plenum into position to finish the installation.
If any questions or problems occur during installation, please contact American Car Craft at 727-861-1500.
Thank You and Enjoy Your Purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520