B&B Electronics ABDN-ER-IN5018 - Quick Start Guide User Manual
First things first, Abdx-er-in50xx, Fast, easy answers
APXG-Q5420
802.11 Wireless Router, Access Point and
Serial Device Server
Document number – PN710-00050-00_R000_ABDx-ER-IN50xx_1413qsg
© 2013 B&B Electronics Manufacturing Company
1-888-948-2248 | Europe: +353 91 792444
www.bb-elec.com
707 Dayton Road | PO Box 1040 | Ottawa, IL 61350
Phone: 815-433-5100 | Fax: 815-433-5109
www.bb-elec.com | E-mail: [email protected]
Fast and easy on the web:
www.bb-elec.com
First Things First...
Before you begin, be sure you have
the following:
Industrial Wireless Ethernet Adapter
Fast, Easy Answers
ABDx-ER-IN50xx
Continuing section 6
Use the Help features of the interface to help you
configure the device. When you are done with
configuring the device, press ‘Commit’ to save the
changes, then ‘Restart’ to restart the device. You
can optionally press ‘Reload’ if you have further
configuration changes to make.
Check Your Setup
7
If your device is connected and configured correctly, you
will see the following LED Status:
COMM:
GREEN
LINK:
GREEN
POST:
GREEN
POWER:
BLUE
8
Troubleshooting
LED
Airborne Device State
POWER
Adapter is not powered.
Adapter is powered
POST
Adapter is not powered.
Adapter failed Power On Self Test (POST) and is not config-
ured for wireless communication.
Adapter passed POST but is not configured for wireless
network communication.
Adapter passed post and is configured for wireless com-
munication.
LINK
Adapter is not powered.
(Periodic Blinking) Adapter is searching for a valid network
(Access Point) that matches device’s configuration.
Adapter has successfully associated with an Access Point.
COMM
If Power LED is also Off then Adapter is not powered.
If Power LED is On then: No TCP session from WLAN or
Ethernet interface has been established.
A TCP connection to the adapter has been established from
the Wireless or Ethernet interfaces but no traffic has been
detected.
First, check your LEDs.
Then use your smart
phone to access complete
documentation on our web
site. Simply scan the code
to the right or visit the
B&B Electronics Knowledge
Base:
ABDx-ER-IN50xx
CD with Airborne Management Center
software
5-36 VDC power for terminal block
or a 5 VDC Power Supply (not included)
50 ohm, omni-directional antenna
APMN-Q551
Embedded Dual Band M2M Access
Point Module
More AirborneM2M Products