B&B Electronics EIRP305-24V-T - Manual - Manual (Page 13)

Manual Documentation Number:
EIRP305-24V-T-0912m
9
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
Wiring the Fault Alarm Contact
The fault alarm contact is in the middle of terminal block connector as the
picture below shows. Inserting the wires will detect the fault status
including power failure and from a Normally Close circuit. Please refer to
Figure-8 for the fault alarm contact, and Figure-9 shows the application
example for the fault alarm operation.
Note:
1. Terminal block rated for 12-24 AWG wire
2. Use copper conductors, 60/75
o
C. Tighten to 5 lb in.