B&B Electronics 860-12100 - Manual - Manual (Page 8)

5
Unmanaged Modules
Before installing, configure the iMcV-10G-Converter modules for desired features.
The DIP Switch settings enable the end user to select the speed/protocol, loopback
modes and Loss Carry Forward (LCF). The table below indicates the available features
and settings for the iMcV-10G-Converter modules.
Switch Function Default
1 “ON” to Enable LOS from XFP1 to XFP2 OFF
2 “ON” to Enable LOS from XFP2 to XFP1 OFF
5 4 3 Combination of settings
OFF OFF OFF Use Internal clock
OFF ON OFF OC-192 SONET/SDH (9.95 Gb/S)
OFF OFF ON 10G Ethernet (10.32 Gb/S)
OFF ON ON 10G Fibre Channel (10.52 Gb/S)
ON OFF OFF ITU G-709 OUT-2 (10.70)
ON OFF ON 10G Ethernet G.702 (11.09Gb/S)
ON ON OFF
5,4,3
ON ON ON
N.A. (default 0,0,0)
OFF/OFF/
OFF
(Ethernet)
6 “ON” to enable FAULT on DDMI alarm OFF
7 Enable Loopback XFP1 OFF
8 Enable Loopback XFP2 OFF