B&B Electronics ISOCON-3 - Manual - Manual (Page 8)

ISOCON-3 USERS GUIDE
4.1.3 Millivolt (mV) Input
Select the range from the table below and set Switch S1 to the required values.
mV Range
1 2 3 4 5 6 7 8 9 10 11 12
0-25mV 0 0 0 0 0 0 0 1 1 1 0 0
0-50mV 0 0 0 1
0-100mV 0 0 1 0
0-125mV 0 1 0 0
0-150mV 1 0 0 0
0-200mV 0 0 1 1
0-250mV 0 1 0 1
0-300mV 1 0 0 1
0-500mV 0 1 1 0
0-600mV 1 0 1 0
0-1000mV 0 1 1 1
0-1200mV 1 0 1 1
-125 to +125mV 1 1 0 0
-125 to +1000mV 1 1 1 1 0 0 0 1 1 1 0 0
Switch S1
And then select the required setting from the table below for switch S2
mV Range
1 2 3 4 5 6 7 8 9 10 11 12
0 1 0 0 0 0 1 1 0 0 0 0
0 1 0 0 1 0 1 0 0 0 0 0
All Unipolar
Ranges (e.g.
0-500mV)
Switch S2
Bipolar Ranges
(e.g.
-125 to +125mV)
!
! WARNING !
DO NOT OPEN UNIT OR ADJUST SWITCHES WITH
POWER SUPPLY, INPUT OR OUTPUT CONNECTED
Please note that PC Software is available to provide information on
switch settings for your input and output requirements.
Page
8 IIG-060901