Electrical characteristics (continued) – Rainbow Electronics MAX3673 User Manual
Page 4
MAX3673
Low-Jitter Frequency Synthesizer
with Selectable Input Reference
4
_______________________________________________________________________________________
ELECTRICAL CHARACTERISTICS (continued)
(V
CC
= +3.0V to +3.6V, T
A
= -40°C to +85°C, C
PLL
= 0.1µF, C
REG
= 0.22µF. Typical values are at V
CC
= +3.3V, T
A
= +25°C, unless
otherwise noted.)
PARAMETER
SYMBOL
CONDITIONS
MIN
TYP
MAX
UNITS
Master Reset (MR) Minimum
Pulse Width
100 ns
Propagation Delay from Input to
FB_IN
FB_SEL = 1 (Notes 8, 11)
-120
+120
ps
Propagation Delay from Input to
Any Output
PLL_BYPASS
=
1
1.0 ns
Note 1:
During the power-on-reset time, the LVPECL outputs are held to logic-low (OUTxx = low, OUTxx = high). See the
Power-
On-Reset (POR) section for more information.
Note 2:
LVPECL inputs can be AC- or DC-coupled.
Note 3:
For hot-pluggable purposes, the device can receive LVPECL inputs when no supply voltage is applied. Measured with
V
CC
pins connected to GND. See Figure 1.
Note 4:
Measured with LVPECL input (V
IH
, V
IL
) as specified.
Note 5:
Measured using reference clock input with 550ps rise/fall time (20% to 80%).
Note 6:
When input differential swing is below the specified threshold, a clock failure is declared. See Figure 4.
Note 7:
LVPECL outputs terminated 50
Ω to V
TT
= V
CC
- 2V.
Note 8:
Guaranteed by design and characterization.
Note 9:
Measured with 50% duty cycle at reference clock input.
Note 10: Measured with 50mV
P-P
sinusoidal noise on the power supply, f
NOISE
= 100kHz.
Note 11: Measured with f
REFCLKx
= f
FB_IN
and matched slew rates.