Cobalt Digital COMPASS 9301 AES Audio Delay - Manual (Page 41)

9301-OM (V4.2) 9301 PRODUCT MANUAL 3-11
Operating Instructions
9301 Function Submenu List and Descriptions
(continued)
Note: • AES Ch 2 thru AES Ch 8 have controls that are identical to the Source, Gain, Delay, and
Phase controls described here for AES Ch 1. Therefore, only the AES Ch 1 controls are
shown here.
• For each channel, its source and destination should be considered and appropriately set.
Unused destination channels should be set to the Silence selection.
• AES Channel Source Using the Source drop-down list, selects the audio source to be routed to
the corresponding AES output channel from the choices described below.
• AES Ch 1 thru AES Ch 16 as Source AES Ch 1 thru AES Ch 16 range in Source drop-down list enables a
discrete AES channel (Ch 1 thru Ch 16) to be the source for the selected
destination AES channel.
(In this example, AES Ch 5 is the source for destination AES Ch 1)
• Tone Generator 1 thru 4 as Source Tone Generator 1 thru Tone Generator 4 range in Source drop-down list
enables one of four tone generators (Tone 1 thru Tone 4) to be the source
for the selected destination AES channel.
(In this example, Tone 1 (tone generator 1) is the source for destination
AES Ch 1)
Note: Tone generator frequencies can be independently set for the four
tone generator sources.
Refer to Tone Generator function description on page 3-19 for
more information.
• Silence (Mute) as Source Silence selection in Source drop-down list mutes the selected destination
AES channel. Use this setting for unused destination channels.
(In this example, silence (muting) is applied to AES Ch 1)
• Gain Control Adjusts and displays relative gain (in dB) applied to the corresponding
destination AES channel.
(-80 to +40 dB range in 0.1 steps; unity = 0.0 dB)
Table 3-1 9301 Function Submenu List — continued
•
•
•