Cobalt Digital COMPASS 9301 AES Audio Delay - Manual (Page 30)

2
Setting Up 9301 Network Remote Control
2-6 9301 PRODUCT MANUAL 9301-OM (V4.2)
Setting Up 9301 Network Remote Control
Perform remote control setup in accordance with Cobalt ® reference guide
“COMPASS™ Remote Control User Guide” (PN 9000RCS-RM).
Note: • If network remote control is to be used for the frame and the frame has not
yet been set up for remote control, Cobalt ® reference guide “COMPASS™
Remote Control User Guide” (PN 9000RCS-RM) provides thorough informa-
tion and step-by-step instructions for setting up network remote control of
COMPASS™ cards using DashBoard™. (Cobalt
® OGCP-9000/CC and
OGCP-9000 Remote Control Panel product manuals have complete instruc-
tions for setting up remote control using a Remote Control Panel.)
Download a copy of this manual by clicking on the DashBoard Control and
Monitoring link at www.cobaltdigital.com and then select DashBoard
Remote Control Manual as a download, or contact Cobalt
® as listed in Con-
tact Cobalt Digital Inc. (p. 1-20).
• If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be dis-
covered by DashBoard™ and be ready for use.
RM20-9301-D-DIN-HDBNC High-density rear modules provides the following
connections:
• Eight coaxial AES-3id audio inputs
(AES IN 1 thru AES IN 8)
• Eight coaxial AES-3id audio outputs
(AES OUT 1 thru AES OUT 8)
Note: Available equipped with High-Density BNC
(HDBNC) or DIN1.0/2.3 connectors as:
RM20-9301-D-HDBNC or RM20-9301-D-DIN,
respectively.
Table 2-1 9301 Rear I/O Modules — continued
9301 Rear I/O Module Description