Installing a rear i/o module, Installation and setup – Cobalt Digital COMPASS 9822 Downconverter User Manual

Page 29

9822-OM (V4.1)

9822 PRODUCT MANUAL

2-3

Installation and Setup

Installing a Rear I/O Module

Note:

The 9822 BNC inputs are internally 75-ohm terminated. It is not necessary to
terminate unused BNC inputs or outputs.

Note:

To remove a card, press down on the ejector tab to unseat the card from the
rear I/O module mating connector. Evenly draw the card from its slot.

10.

If network remote control is to be used for the frame and the frame has
not yet been set up for remote control, perform setup in accordance with
Setting Up 9822 Network Remote Control (p. 2-6).

Note:

If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be dis-
covered by DashBoard™ and be ready for use.

Installing a Rear I/O Module

Note:

This procedure is applicable only if a Rear I/O Module is not currently
installed in the slot where the 9822 is to be installed.

If installing the 9822 in a slot already equipped with a suitable I/O module,

omit this procedure.

Install a Rear I/O Module as follows:

On the frame, determine the slot in which the 9822 is to be installed.

In the mounting area corresponding to the slot location, install
Rear I/O Module as shown in Figure 2-1.