Moog Music SUB PHATTY - Manual (Page 32)

32
AMPLIFIER ENVELOPE KEYBOARD AMOUNT
When amplifier envelope keyboard tracking is enabled,
the amplifier’s envelope times will respond to how
high or how low you play on the keyboard. Engage
Shift mode, press the
BANK 4 and PATCH 4 buttons,
and press any key besides low C to make the amplifier
envelope track the keyboard. The higher the key you
press, then the more keyboard tracking will affect
envelope times. Engage Shift mode, press the
BANK
4 and PATCH 4 buttons, and press low C to turn off
keyboard tracking.
AMPLIFIER ENVELOPE GATE
You can control whether the amplifier envelope is
triggered by the keyboard, by an external control-
voltage source, by both, or whether the envelope is
always on. Engage Shift mode and press the
BANK
4, PATCH 1, and PATCH 2 buttons. Pressing the low C
key leaves the gate open and bypasses the envelope
generator. When you press C#, only the keyboard or a
MIDI signal will trigger the envelope. When you press D,
only a gate (CV) signal routed from an external source
to the
GATE CV jack will trigger the envelope. When
you press D#, the keyboard, a MIDI signal, or an external
gate signal will trigger the envelope (default).
MIDI IN CHANNEL
By default, the Sub Phatty sends and receives data on
MIDI Channel 1, but you can set it to send or receive on
any MIDI Channel from 1 to 16.
To change the input channel, engage Shift mode and
press the
BANK 1, BANK 4, and PATCH 1 buttons. The
next key you press will determine the input channel.
Pressing the low C selects Channel 1, C# selects
Channel 2, and so on, all the way up to D# above middle
C, which selects Channel 16.
G
a
te Open (Alw
a
y
s On)
G
ate
C
V
KB or MIDI KB, MIDI, or G
at
e C
V
MIDI PARAMETERS
Shift mode lets you modify the Sub Phatty’s default MIDI settings. You can change the MIDI transmit
and receive channels, turn local control on and off, filter MIDI data, enable and disable fine-resolution
data recognition, and enable and disable the DIN or USB ports to send, receive, and merge MIDI data.
Changing some MIDI settings requires that you press two
BANK buttons and one PATCH button in
Shift mode.
Channel 1 Channel 3 et
c....
Channel 2 Channel 4
K
e
yboar
d T
racking OFF