Moog Music SUB PHATTY User Manual

Page 30

elope Reset OFF

elope Reset ON

FILTER ENVELOPE RESET

When Filter Envelope Reset is turned on, each new note
triggers the filter envelope to reset from zero, so its
output sweeps fully from zero to maximum with each
attack. By default, with envelope reset turned off, an
envelope Attack sweeps the envelope output only from its
current level to maximum. The effect of Envelope Reset is
more prominent with longer attack and release times.

To change this function, engage Shift mode and press
the

BANK 3 and PATCH 2 buttons. Pressing the low C

key turns Filter Envelope Reset off, and pressing C#
turns it on.

FILTER ENVELOPE REPEAT

Normally, an envelope occurs just once when you play a
note. It’s possible, however, to use the filter’s envelope
generator as a multistage LFO for controlling cutoff,
pitch, or waveform. When filter envelope repeat is
enabled, then the delay, attack, hold, decay, and release
stages will loop continuously for as long as the note is
held. The shorter the envelope times, the faster the loop
will repeat.

To turn on filter envelope repeat, enable Shift mode, press
the

BANK 3 and PATCH 3 buttons, and press the C# key.

Pressing the C key turns off filter envelope repeat.

FILTER ENVELOPE KEYBOARD AMOUNT

When filter envelope keyboard tracking is enabled,
the filter’s envelope times will respond to how high or
how low you play on the keyboard. Engage Shift mode,
press the

BANK 3 and PATCH 4 buttons, and press any

key besides low C to make the filter envelope track the
keyboard. The higher the key you press, then the more
keyboard tracking will affect envelope times. Engage
Shift mode, press the

BANK 3 and PATCH 4 buttons,

and press low C to turn off keyboard tracking.

FILTER ENVELOPE GATE

You can control whether the filter envelope is triggered
by the keyboard, by an external control-voltage source,
by both, or whether the envelope is always on. Engage
Shift mode and press the

BANK 3, PATCH 1, and PATCH

2 buttons. Pressing the low C key leaves the gate open
and bypasses the envelope generator. When you press
C#, only the keyboard or a MIDI signal will trigger the
envelope. When you press D, only a gate signal routed
from an external source to the

GATE CV jack will trigger

the envelope. When you press D#, the keyboard, a
MIDI signal, or an external gate signal will trigger the
envelope (default).

elope Repea

t OFF

elope Repea

t ON

yboar

d T

racking OFF

te Open (Alw

s On)

ate

KB or MIDI

KB, MIDI, or G

te C