beautypg.com

Model 5600, Installation and start-up procedure, Page 3 – Peerless Water 5600_5600 Econominder User Manual

Page 3

background image

Printed in U.S.A.

Page 3

MODEL 5600

Installation and Start-Up Procedure

The water softener should be installed with the inlet, outlet and drain connections made in accordance with
manufacturer’s recommendations and to meet applicable plumbing codes.

1. Manually index the softener control into the service

position and let water flow into the resin tank. When
the water flow stops, open a softened water tap until
all air is released from the lines, then close the tap.

Note: the various regeneration positions may be
dialed manually by turning the knob on the front of the
control until the indicator shows that the softener is in
the desired position.

2. Manually index the control to the backwash position

and allow water to flow at the drain for 3 or 4 minutes.

3. Remove back cover plate.

4. Make sure that the salt dosage is set as

recommended by the manufacturer. If necessary, set
salt in accordance with the setting instruction sheet.
Manually index the control to the brine fill position and
allow the brine tank to fill to the top of the air check.

5. Manually index the control to the brine draw position

and allow the control to draw water from the brine
tank until it stops.

6. Plug in the electrical cord and look in the sight hole in

the back of the motor to see that it is running. Set the
days that regeneration is to occur by sliding tabs on
skipper wheel outward to expose trip fingers. Each
tab is one day. Finger at red pointer is tonight. Moving
clockwise from red pointer, extend or retract fingers to
obtain the desired regeneration schedule.

7. Manually advance the control to the beginning of the

brine fill position; and allow the control to return to the
service position automatically.

8. Fill the brine tank with salt.

9. Replace back cover on the control.

10. Make sure that any by-pass valving is left in the

normal service position.

MANUAL

REGENERATION KNOB

24 HOUR GEAR

RED TIME

SET

BUTTON

SKIPPER WHEEL

(SHOWS EVERY

OTHER DAY

REGENERATION)

TIME OF DAY ARROW

RED POINTER