Daystar KC09122-1 - Manual (Page 2)

Thank you for choosing Daystar Products
Daystar recommends a certified technician install this system. In addi-
tion to these instructions, professional knowledge of disassembly/
reassembly procedures as well as post instruction checks must be
known. Attempts to install this system without this knowledge and
expertise may jeopardize the integrity and/or operating of the vehicle.
Please read all the instructions before beginning the installation. Check
the kit hardware against the parts list. Be sure you have all the needed
parts and understand where they go. If anything is missing , do not
proceed with the installation, Call Daystar Products to obtain needed
items.
Product Use Information
As a general rule, the taller a vehicle is the easier it will roll. We
strongly recommend, because of rollover possibility, that seat belts and
shoulder harness be worn at all times. Avoid situations where a side
rollover may occur.
Braking performance and capabilities are decreased when significantly
larger/heavier tires and wheels are used. Take this into consideration
while driving, Also, speedometer recalibration is necessary when larger
tires are installed.
Do no add, alter, or fabricate any factory or after-market parts which
increase vehicle height over the intended height of the Daystar Product
purchased. Mixing component brands, lifts, and/or combining body lift
with a suspension lift voids all warranties. Daystar makes no claims
regarding lifting devices and excludes any and all implied claims. We
will not be responsible for any product that is altered.
Notice to Dealer and Vehicle Owner
Any vehicle equipped with any Daystar Product must have the “Warning
to Driver” decal installed on the sun visor or dash. The decal is to act as a
constant reminder for whoever is operating the vehicle of its unique han-
dling characteristics. INSTALLING DEALER— It is your responsibility
to install the warning decal and forward these instructions on to the vehi-
cle owner for review and to be kept in the vehicle for service life.
After installation occurs, a qualified alignment facility is required to align
the vehicle to factory specs.
16. Install the upper shock mount first.
17. Place the coil in the lower axle spring mount and jack up
the axle to install the lower shock bolts and nuts.
18. Lower the jack down to full droop. The shock should
not extend far enough to allow the coil to come out.
19. Jack up the axle and reconnect the sway bar end link.
20. Re-attach the ABS and brake lines to the axle.
21. Reinstall the tires and torque to factory specifications.
Lower the vehicle to the floor.
22. Cycle the steering lock to lock and double-check all com-
ponents for proper clearances and torque. Test drive the
vehicle.
23. The vehicle now requires a professional wheel alignment.
It should be aligned to factory specifications.