Daystar KN09104 User Manual
Warning
KN09104 – Nissan 2004-12 Titan 2 1/2” Lift
Instruction Sheet P11073-01
2005 Daystar Products International Inc.
www.DaystarWeb.com
Tech Support Contact Info
Phone: 623.907.0081
Fax: 623.907.0088
841 South 71
st
Avenue
Phoenix, AZ 85043
IMPORTANT NOTE: The advertised amount of lift that this kit provides and the thickness of the spacers
supplied will not be the same! For example, a 2-1/2” lift may only have 1-1/2” thick spacers. The reason for the
difference between the spacer thickness and the amount of lift has to do with suspension geometry. There is a
ratio involved, and it is this ratio that determines the thickness of the spacers. Rest assured, installing the
spacer supplied will result in the proper amount of lift out at the wheel.
1.
Layout all parts and check quantities against the Bill of Materials. Completely read instructions
before beginning installation.
2.
Do not install the kit on another lift or altered suspension.
3.
Jack the front of the vehicle in accordance to manufacturer recommendation and support with jack
stands, so that the front two tires are off the ground
4.
Remove the front tires/wheels.
5.
Remove sway bar end link.
6.
Remove upper ball joint nut and remove spindle from upper A-arm.
7.
Remove upper strut nuts on the strut tower (3) on each side of vehicle that holds strut assembly to
the strut tower (Hint: Leave one nut on to prevent the strut from dropping out in the next step.)
8.
Remove lower strut bolt from the lower control arm and remove the strut assembly from vehicle.
(Note the direction of the bolt for reinstallation)
9.
Install the 3 washers on the plate then the stud extenders with the M03875 spacer on top of strut assembly.
10. Install the strut assembly into the strut tower and start the upper three 10mm nuts & washers. (Make sure that the bottom of the strut is
aligned as well)
11.
Install the lower strut bolt in the original position that it was removed.
12.
Using the floor jack, raise the lower control arm and connect the upper ball joint on the upper control arm to the spindle. Torque per OEM
specifications.
13.
Reconnect the sway bar end links. Torque per OEM specifications.
14.
Install the front tires/wheels.
15.
Lower the vehicle onto the ground and tighten the upper strut tower nuts. (3 on each side).
16.
Torque all bolts to factory specifications.
17.
Have wheel alignment done after installation.
18.
Re-torque all bolts after 500 miles.
WARNING
This vehicle has been modified to enhance its performance. The steering, braking and handling of this vehicle will
differ from standard passenger cars and trucks; this vehicle handles differently from an ordinary vehicle in driving
conditions which may occur on streets, highways and off road.
Avoid unnecessary abrupt maneuvers, sudden stops, sharp turns and other driving conditions that could cause
loss of control, possibly leading to a roll over or other accident that could result in serious injury or death to driver and
passengers. If larger tires are installed the speedometer will read lower than the vehicles actual speed.
DRIVE WITH CARE, REDUCE SPEED AND WEAR SEAT BELTS AT ALL TIMES.
Do not combine with any other suspension kit.
This kit should be installed by a professional mechanic.
Tools required
Description
Qty.
Wrench set & Socket set
1
Floor Jack
1
Jack Stand
2+
Bill of Materials
Part #
Description
Qty
M03875
Top spacer
2
S11134
Stud extender
6
S10518
10mm-1.25 lock nut
6