Daystar KG09123 User Manual
Daystar For the car
TOOLS NEEDED
Floor Jack X 1
Jack Stands X 2
Puller Tool X 1
Hand Tools
BILL OF MATERIALS
S20612 X 2 Torsion Keys
P20724 X 1 Instructions
S20721 X 2 Shock extenders
IMPORTANT: The net amount of ride height increase de-
pends upon the age and use of the vehicle, wheel offset, and
numerous other factors. Stated torsion bar ride height in-
creases are based upon factory specifications. If the torsion
bars were “cranked up” at some point in the past, expect a
corresponding reduction in overall height increase with the
new torsion keys. Note that torsion bars, like any other
spring, are subject to fatigue and sagging over time. Also,
torsion bars have different ratings depending on how the vehi-
cle was equipped from the factory. In some cases, installing
heavier rated bars (which can be purchased from a dealer)
may be the only solution to regaining ride height lost from
adding heavy aftermarket accessories, such as a winch
bumper or snow plow
.
NOTE: Various types of puller tools are available, however, due to the
extreme loads present in four-wheel drive suspension systems, we have
found the two-jaw style tool that clamps to the crossmember tends to slip
and damage the crossmember. A C-clamp style puller tool is preferred
and available through tool companies such as OTC and Kent Moore.
WWW.DAYSTARWEB.COM
Instruction Sheet P20724
2007 Daystar Products International Inc.
www.Daystarweb.com
Tech Support Contact Info
Phone: 623.907.0081
Fax: 623.907.0088
841 South 71
st
Avenue
KG09123
2011-12 2500/3500 HD 8 LUG 4WD
TORSION BAR LEVELING KIT