Daystar KT09112BK User Manual
Page 2
KT09112
1996-2001 4-Runner 2WD & 4WD
1 ½” Front Coil Spring Spacer Lift Kit With Rear Coil Spring Spacers
INSTALLATION INSTRUCTIONS
REAR
www.DaystarWeb.com
Tech Support Contact Info
Phone. 623.907.0081
Fax. 623.907.0088
841 South 71
st
Avenue
Phoenix, AZ 85043
1. Jack up rear end and place jack stands under frame allowing rear suspension to move up and down freely.
2. Disconnect lower shock mount bolts/nuts so that the rear axle droops and the coil springs become loose.
3. Disconnect the panhard bar at the drivers side of the axle.
4. Remove the coil spring and the coil spring isolator/bump-stop.
5. Place the isolator/bump-stop into the new coil spring spacer and then onto the frame. Reinstall the coil
spring in between the coil spring spacer and the axle. (Note: you may have to pry the coil spring onto the
axle pad.)
6. Jack up the rear suspension so that the coil spring seats into the coil spring spacer and on the axle pad.
Reconnect the lower shocks mount bolts/nuts and reconnect the panhard bar.
7. Jack up the rear of the vehicle, remove the jack stands and lower the vehicle. Check all bolts/nuts for
tightness and recheck after 500 miles.
Instruction Sheet Page 2 of 2
P10513 Rev03
© 2006 Daystar Products
International Inc
.