Daystar KJ71030 - Manual (Page 3)

9. Install the 2 clips on to the switch panel by pushing down on the clips
with your hand.
10. Wire your switches.
11. Install the switch panel by putting the lower pins in first then push the
top of the panel back to snap in the clips( 2 ).
Installation steps
1. Place the e-brake and pull the 4wd lever back to neutral and place the
trans in 2nd gear, a manual trans put in 2nd gear.
2. Place a paper towel on the center dash panel so not to scratch the panel.
With the paper towel in place , slide the screw driver between the dash
and lower panel.
3. Push screw driver to the side to release the clips. Pull back the panel
with your hand and remove panel.