Daystar KT09115-2 User Manual
Daystar For the car
Tech Support Contact Info
Phone: 623.907.0081
Fax: 623.907.0088
841 South 71
st
Avenue
Phoenix, AZ 85043
KT09118 / KT09115 Toyota 2003-04 4-Runner 1.5”
Rear Coil Spring Spacer Instructions
1. Jack up rear end and place jack stands under frame allowing rear suspension to move
up and down freely.
2. Disconnect lower shock mount bolts/nuts so that the rear axle droops and the coil
springs become loose.
3. Disconnect the pan-hard bar at the drivers side if the axle.
4. Remove the coil spring and the coil spring isolator/bump-stop.
5. Install the isolator/bump-stop into the new coil spring spacer and then onto the frame.
Install the coil spring in between the coil spring spacer and the axle. (Note: you may
have to pry the coil spring onto the axle pad.)
6. Jack up the rear suspension so that the coil spring seats into the coil spring spacer and
on the axle pad. Reconnect the lower shocks mount bolts/nuts and reconnect the pan-
hard bar.
7.
Jack up the rear of the vehicle, remove the jack stands and lower the vehicle. Recheck
all bolts/nuts after 500 miles for tightness.
BOM
M03531 X 2 REAR SPACER
Instruction Sheet P10670 Rev00
© 2009 Daystar Products International Inc.