Daystar KF09110-1 - Manual

TOOLS NEEDED BILL OF MATERIALS
Part No. Description Qty
M03876 Front Spacer 2
S11094 Stud extenders 6
S10010 10mm Washer 6
S10292 10mm –1.5 lock nut 6
P11153 Thread lock 1
Description Qty
Floor Jack 1
Jack Stands 2
Lug Wrench 1
10mm wrench 1
17mm wrench 1
20mm wrench 1
21mm wrench 1
Torque wrench 1
Pry Bar 1
17. Install the tire/wheels.
18. Lower off the Jack stands and place back on the ground.
19. Wheel alignment is required.
20. Check all bolts/nuts after 500 miles.
IMPORTANT NOTE: The advertised amount of lift that this kit provides and the thick-
ness of the spacers supplied will not be the same! For example, a 2-1/2” lift may only
have 1-1/2” thick spacers. The reason for the difference between the spacer thickness
and the amount of lift has to do with suspension geometry. There is a ratio involved,
and it is this ratio that determines the thickness of the spacers. Rest assured, installing
the spacer supplied will result in the proper amount of lift out at the wheel.
Instruction Sheet P10597-05
2007 Daystar Products International Inc.
www.Daystarweb.com
Tech Support Contact Info
[email protected]
Phone: 623.907.0081
Fax: 623.907.0088
841 South 71 st Avenue
KF09111
FRONT SPACER LIFT 2.5”
2004-08 FORD F150 2WD & 4WD
2003-07 FORD EXPEDITION
EASY INSTALL KIT