Daystar KJ03007BK User Manual
Installation instructions
KJ03007 Jeep TJ Rear Control Arm Bushing Kit 1997-2001
Installation Instructions
1. Please read the instructions completely and check the Bill of Material before beginning the installation.
2. Raise and support the vehicle with jack stands in front of the rear leaf spring perches so that the tires
just touch the ground.
3. Remove one control arm at a time noting its position and how it is installed. On the upper control arms
you will have to remove the E-brake cables.
4. Remove the factory rubber bushings by burning out the centers with a suitable propane or acetylene
torch. DO NOT damage the outer shells, as they will be reused.
5. Clean the outer shells with a suitable tool so that they are free and clear of any debris.
6. Using the supplied Daystar Lubrethane, install the corresponding bushing, thrust washer, and steel
sleeve into the control arm sleeve per the figures below.
7. Reinstall the control arm from the position in which it was removed and torque to factory specifications.
8. Complete this for the other three control arms.
9. Recheck all bolts and re-torque after 500 miles.
www.DaystarWeb.com
Tech Support Contact Info
Phone: 623.907.0081
Fax: 623.907.0088
841 South 71
st
Avenue
Phoenix, AZ 85043
Instruction Sheet P10521-00
2000 Daystar Products International Inc.
Bill Of Materials
Part No.
Description
Qty.
M02413
Bushing
4
M02409
Thrust Washer
4
M02414
Bushing
4
M02411
Thrust Washer
4
S10091
Steel Sleeve
4
S10092
Steel Sleeve
4
A01133
Daystar Lubrethane
1