Daystar KJ09143BK-1 - Manual (Page 2)

Thank you for choosing Daystar Products
Daystar recommends a certified technician install this system . In addition to
these instructions, professional knowledge of disassemble/reassembly proce-
dures as well as post instructions checks must be known. Attempts to install this
system without this knowledge and expertise may jeopardize the integrity and/or
operating of the vehicle.
Please read all the instructions before beginning the installation. Check the kit
hardware against the parts list. Be sure you have all the needed parts and under-
stand where they go. If anything is missing , do not proceed with the installa-
tion, Call Daystar Products to obtain needed items.
Product Use Information
As a general rule, the taller a vehicle is the easier it will roll. We strongly recom-
mend , because of rollover possibility, that seat belts and shoulder harness be
worn at all times. Avoid situations where a side rollover may occur.
Braking performance and capabilities are decreased when significantly large/
heavier tires and wheels are used. Take this into consideration while driving,
Also , speedometer recalibration is necessary when larger tires are installed.
Do not add, alter, or fabricate any factory or after-market parts which increase
vehicle height over the intended height of the Daystar Product purchased. Mixing
component brands, lifts, and/or combining body lift with suspension lift voids all
warranties. Daystar makes no claims regarding lifting devices and excludes any
and all implied claims. We will not be responsible for any products that is al-
tered.
Notice to Dealer and Vehicle Owner
Any vehicle equipped with any Daystar Product must have the “Warning to
driver” decal installed on the sun visor or dash. The decal is to act a constant re-
minder for whoever is operating the vehicle of its unique handling characteristics.
INSTALLING DEALER— Its is your responsibility to install the warning decal
and forward these instructions on too the vehicle owner for review and to be kept
in the vehicle for service life.
After installation occurs, a qualified alignment facility is required to align the
vehicle to factory specs.
11. With the coil removed , install the rear lift spacer over the stock
spring isolator and install the coil springs.
12. Raise up the rear axle to reconnect the shocks and install the rear
sway bar and brake line bracket.
13. For 1 3/4 lift you will need to install the sway bar drop bracket be-
tween the sway bar mount and the frame. Install the 2 sleeves into
the drop bracket and place between the frame and sway bar, using
the supplied longer bolts and loctite.
14. Install the rear wheels and lower back on the ground.
15. You will need to have your wheel alignment checked.
16. Check all bolts and nuts after 500 miles and lug nuts.
Drop bracket
Sleeve