Daystar KT09119BK User Manual
Page 2
www.DaystarWeb.com
Tech Support Contact Info
Phone: 623.907.0081
Fax: 623.907.0088
841 South 71
st
Avenue
Phoenix, AZ 85043
KT04506 1995.5 -2004 Toyota Tacoma 1” Body Lift Kit
Bed Installation
1.
Loosen the 6 bed mount bolts. Remove 3 bolts from one side. Place a 2x4 between the jack and bed to spread out load.
2.
Raise the bed on the side you have removed the bolts from just far enough to install the rectangular steel tube bed spacers and start the new
supplied 12mm bolts. The bolts on the opposite side will help ensure that the bed does not shift. See figure 3.
3.
Install the rectangular polyurethane bed spacer on to the bed, sliding the clip into the bed rail support near the tire. See figure 4.
4.
Remove bolts from other side of bed and repeat steps 2 and 3.
5.
Once all new mounts are in place, align the bed with the cab. Re-torque all bolts to 60ft lbs, DO NOT over tighten bolts.
6.
Before starting engine, check fan for clearance from fan shroud and make sure all lines and wires are free and clear.
P10720 REV01
© 2004 Daystar Products International
Inc.
WARNING
This vehicle has been modified to enhance its performance. The steering, braking and handling of this vehicle will differ from
standard passenger cars and trucks, This vehicle handles differently from an ordinary vehicle in driving conditions which may occur
on streets, highways and off road. Avoid unnecessary abrupt maneuvers, sudden stops, sharp turns and other driving conditions
that could cause loss of control, possibly leading to a roll over or other accident that could result in serious injury or death to driver
and passengers. If larger tires are installed the speedometer will read lower than the vehicles actual speed.
DRIVE WITH CARE, REDUCE SPEED AND WEAR SEAT BELTS AT ALL TIMES.
This kit should be installed by a professional mechanic.
Figure 2.
Figure 4.
OE Upper
Steering Coupler
to column.
S10776 Aluminum
Steering Coupler
OE Lower Steering
Coupler on Rack &
Pinion
Insert rectangular
polyurethane bed
spacer in wheel
well onto bed
support.
S10775 Bed
Tubing Spacer
S10773 Bolt
S10128 Washer
Frame Rail
OE Bed Nut
Bed Support
Figure 3.