Daystar KF09052-1 - Manual

KF09049BK Ford 2005 -12 4WD Super Duty
Front Coil Spring Spacer Lift Kit
Instruction Sheet P20448
Page 1 of 2
 2004 Daystar Products International Inc.
www.DaystarWeb.com
Tech Support Contact Info
[email protected]
Phone: 623.907.0081
Fax: 623.907.0088
841 South 71
st
Avenue
Phoenix, AZ 85043
Step(s) (DO NOT COMBINE WITH ANY OTHER SUSPENSION KIT)
1. Layout all parts and check quantities against the Bill of Materials. Completely
read instructions before beginning installation.
2. Make sure you are working on a level, stable concrete surface or using a lift to
perform this work.
3. Jack up the front of the vehicle in accordance to manufacturer recommendation
and support vehicle with jack stands, use the floor jacks to support the axle so
it can be lifted and lowered relative to the vehicle.
4. Remove front wheels.
5. Raise the axle using the floor jacks enough to relieve tension in the
shocks.
6. Disconnect end links to sway bar, brake line bracket and OE shocks
(both sides). Fig.1
7. Lower the front axle as far as possible. Remove only one spring
(mark or note spring orientation before removal). Remove OE spring
isolator.
8. Compress spring down, install new isolator (M03634) and reinstall
spring.
9. Repeat steps 7 and 8 for other side.
10. Lift axle back up and install the brake line bracket (Fig.3) and
reconnect sway bar end links.
Tools required
Description: Qty.
Wrench set & Socket set 1
Coil Spring Compressor 2
Floor Jacks / Jack Stands 2/4
Bill of Materials
Part No. Description Qty
M03634 Coil Spring Spacer 2
Fig. 1
Fig. 2
Shock Absorbers
Description: Qty.
H7091S Front Shock 2
H7073S Rear Shock 2
BU01001 Front Shock
hardware bag
1
BU01016 Rear Shock
Hardware Bag
1