Daystar KJ09143BK-2 - Manual (Page 4)

4. With a 16mm socket loosen the two nuts at each of the body mounts, with a
18mm socket loosen the one bolt at each of the body mount. DO NOT re-
move at this time. 2dr 10 mount / 4 door 12 mount locations.
5. Place the floor jack under the Jeep tub between the front and rear wheel. Rise
up the jack with the 2x4 block of wood on top of the jack and remove only
one side of the bolt and nuts from the Jeep.
6. Slowly raise up the jeep with the block of wood between the jack and the tub
of the Jeep, about 4” off the body mounts and place a 4x6 piece f wood be-
tween the frame and the jeep tub. Remove one mount at a time.
7. Place thread lock on the stud extenders.( 2 at a time ) Using a 5/8 wrench in-
stall the extenders on the body mount and tighten down
8. With the extenders tight install the body mount spacer over the stock mount.
9. With the spacer mount installed. Install the mount into the fame support.
( Note) When installing the front grill mount put the 2 studs in grill frame first,
using the 2 studs and nut to hold the mount in the grill.
10. Repeat steps 7 to 9 with the remainder of the mounts on this side.
11. After you have installed on one side remove the 4x6 block of wood and lower
down the Jeep tub onto the body mounts and install the 2 nuts and 1 bolt per
mount and had tighten down and move the floor jack over to the other side and
repeat steps 5 through 10. If all the mounts have been installed, remove the 4x6
block of wood and lower jeep tub onto the body mounts
.