Daystar KJ09153BK - Manual (Page 4)

3. Disconnect the ABS line form the bracket on the steering knuckle on
the driver side then the passenger side. Remove the factory shocks.
4. With the shocks removed , sway bar end links, and ABS line discon-
nected, lower the axle down to remove the coil springs on the driver
side first then the passenger side.
16. After drilling the 2 holes place the track bar bracket on the axle.
17. Install the supplied sleeve and stock track bar bolt in the lower
mounting hole.
Sleeve
18. Install the supplied 3/8” x 1” bolts in the holes just drilled. Tighten
the stock track bar bolt and the 3/8” bolts.
19. Position the track bar in the upper portion of the track bar bracket and
secure is using the supplied 9/16” x 3” bolt, washer and nut. Tighten.