RAM Mount RAP-354 - Manual

RAP-B-354 & RAP-354
ASSEMBLY INSTRUCTIONS
PART INDEX
National Products, Inc., 1205 S. Orr St., Seattle, WA 98108, (206) 763-8361 www.RAM-MOUNT.com
A:
RPR-351-WBB RUBBER
B: FLANGE
C: RPR-351-W88: RAM .87” OD PLASTIC WEDGE LOCK
D:
E: O
F:
RPR-351-WBC: RAM PLASTIC BASE WITH 1.5”
(OR 1” - ) DIA. BALL
RPR-351-W88F: RAM .87” OD WEDGE LOCK W/ 6 PIN
.360” OD X 2.10” LONG SPRING
#10-24 x 4” L NG SCREW
#10-24 NYLOCK NUT
RAP-354U
STEP 1: Place screw (E) through base with ball (A)
STEP 2: Slide Flange (B) over screw (E) and align with base (A)
STEP 3: Place spring (D) over screw (E)
STEP 4: Place wedge lock (C) over screw (E) and align with flange (B)
STEP 5: Squeeze wedge lock (C) and spring (D) down until screw (E)
is exposed from the nut recess, install and tighten nut (F) by hand to
hold part in place.
STEP 6: Place assembled RAP-354U or RAP-B-354U in desired
location and tighten screw with screw driver until RAP-354U is wedged
tight in space
A
E
E
B
B
E
D
B
C
C
F
A
A
A
A
B
C
D
E
F
STEP 1 STEP 2 STEP 3 STEP 4 STEP 5
STEP 6