RAM Mount RAM-VB-107-SW1 User Manual

Ram no-drill, Seat bases, Vehicle base for the

This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.

Vehicle base for the

SPECIFICATIONS

Placement
Across transmission hump

Drilling Required
No - uses existing seat bolts

Seat Configuration
Bucket/60-40 split

Construction/Finish
Steel/Black Powdercoat

Pole or Pedestal
Ordered Separately

Weight
7.3 lbs.

Dimensions
A = 8.75", B = 5", C = 5.75", D = 9.25”

Notes

Central mounting location moves pole away from passenger leg
space. There base is formed from one piece of steel. Drilling
may be required on vehicles with 60-40 split seats.

RAM No-Drill

Seat Bases

National Products, Inc.

Item Number
RAM-VB-107 & RAM-VB-107-SW1

CHEVROLET CAPRICE (1990-1995)
FORD CROWN VICTORIA/POLICE INTERCEPTOR (1991-2011)

National Products, Inc.

Website: www.ram-mount.com
Email: [email protected]

8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615

National Products, Inc.

Website: www.ram-mount.com
Email: [email protected]

8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615

Complete Vehicle Mount

RAM-VB-107-SW1

Vehicle Base

RAM-VB-107

Vehicle base for the

INSTALLATION INSTRUCTIONS

1. Place both front seats in their most rear position.

2. Remove the drivers side front right and the passenger side front left seat mounting bolts (inner seat bolts).

3. Slightly lift both the passenger and driver seats and slide the No-Drill™ base between the floor of the vehicle and the
bottom of the seat.

4. Align the holes and reinstall all of the seat bolts that have been removed.