RAM Mount RAM-VB-138ST1-SW1 - Manual

This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
Vehicle base for the
SPECIFICATIONS
Features
Notes
Installs in minutes with no drilling required
Low profile keeps mount away from passenger leg space
The RAM-VB-138ST1 will not fit BENCH SEAT MODEL TRUCKS
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-138ST1 & RAM-VB-138ST1-SW1
Complete Vehicle Mount
RAM-VB-138ST1-SW1
Vehicle Base
RAM-VB-138ST1
Placement
Passenger side on the floor, under front seat
Drilling Required
No - uses existing seat bolts
Seat Configuration
Bucket
Construction/Finish
Steel/Black Powdercoat
Dimensions
Pole or Pedestal
Sold Separately
Weight
7.0 lbs.
A = 17.125", B = 6.5", C = 5”
Hole Centers = 15.875”
TOYOTA FJ CRUISER (2006-2013)
National Products, Inc.
Website: www.ram-mount.com
Email: [email protected]
8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615
National Products, Inc.
Website: www.ram-mount.com
Email: [email protected]
8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615
Vehicle base for the
INSTALLATION INSTRUCTIONS
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-138ST1 & RAM-VB-138ST1-SW1
1. Attaching the fixed Adjust-A-Pole™ to the No-Drill™ base should be done prior to attaching the base to
the vehicle. For a finished look, assemble so the rounded heads of the carriage bolts are on top.
2. Move the passenger seat back to its rearmost position and remove the front seat rail bolts using a 14mm
socket wrench. Save and store these bolts should the mount be later removed.
3. Using the provided hardware, place the washers over the longer bolts, pass the bolts through the No-
Drill™ base, next through the round stand-offs, and align over the threaded holes in the floor board.
4. Start bolts by hand to insure that the bolts do not cross thread
5. Using a 17mm socket wrench, fully tighten the bolts to secure the base.
6. After a day of use, re-tighten the seat bolts holding the mount.
TOYOTA FJ CRUISER (2006-2013)