RAM Mount RAM-VB-116-SW1 User Manual

Ram no-drill, Seat bases, Vehicle base for the

This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.

Vehicle base for the

SPECIFICATIONS

Placement
Passenger side on the floor, in front of seat

Drilling Required
No - uses existing seat bolts

Seat Configuration
Bucket/Bench

Construction/Finish
Steel/Black Powdercoat

Dimensions

Tools required for base installation

18mm box end wrench, 18

mm socket

, universal joint adaptor or

wobble, and socket wrench

for base installation

Tools for complete

system assembly: pliers, phillips screw driver, #10, ½”,

9/16”

box

end wrench’s.

Pole or Pedestal
Ordered Separately

Weight
10.7 lbs.

A = 14", B = 4.75", C = 5.5", D = 17”
Hole Center = 11.75”

Features

Important Note

Installs in minutes with no drilling required
Angled step moves pole away from passenger leg space
Won’t interfere with levers or factory-installed console or 4WD lever

The RAM-VB-116 base will not fit crew cab vehicles where the
vent duct passes under the front of the passenger seat. Consider
attaching the riser to the no drill base prior to vehicle installation.

RAM No-Drill

Seat Bases

National Products, Inc.

Item Number
RAM-VB-116 & RAM-VB-116-SW1

RAM-VB-116, SHOWN WITH

RAM-VB-SB4 RISER (INCLUDED)

CHEVROLET COLORADO (2004-2012)
GMC CANYON (2004-2012)

Complete Vehicle Mount

RAM-VB-116-SW1

National Products, Inc.

Website: www.ram-mount.com
Email: [email protected]

8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615

National Products, Inc.

Website: www.ram-mount.com
Email: [email protected]

8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615

Vehicle base for the

INSTALLATION INSTRUCTIONS

Tools required for installation are an 18mm socket, and ½” box end wrench. You may also consider using a wobble
adapter or universal joint style extension to aid in the installation of the hump side seat leg bolt.

1. Attach the adjustable riser to base with the provided carriage bolts, washers, and nuts. Use the ½” box end wrench
to fully tighten the riser to the base.

2. Move the passenger seat to the rearmost setting.

3. Remove the front seat rail bolts that fasten the passenger seat brackets to the vehicle floor using the 18mm socket.

4. Pass the bolts you just removed through the holes in the No-Drill™ base.

5. Place the base with bolts over the seat frame legs, align the bolts with the holes, and start the thread by hand into
the vehicle floor board.

6. Once both bolts have been started by hand, use the 18mm tools and fully tighten to 35 ft lbs.