RAM Mount RAM-VB-102-SW1 - Manual

This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 8410 Dallas Ave S
Seattle, WA 98108
Website: www.ram-mount.com
Email: [email protected]
Vehicle base for the
SPECIFICATIONS
Placement
Installs on passenger side in between seat
Cushion and seat rails.
Drilling Required
None - uses existing seat bolts
Seat Configuration
Bucket
Construction/Finish
Steel/Black Powdercoat
Dimensions
Pole or Pedestal
Ordered Separately
Weight
6.9 lbs.
A = 16", B = 8", C = 4.69", D = 6.75", E = 4”
Hole Center = 11.75”
Notes
For vehicles with power seats please see RAM-VB-131A .
Angled step moves mount away from passenger leg space.
There are a total of 3 pieces of steel that make this part, 2
are welded together and the 3rd is bolted. Base will not
interfere with factory installed console or 4WD lever.
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-102 & RAM-VB-102-SW1
RAM-VB-102, SHOWN WITH
RAM-VB-SB4 RISER (INCLUDED)
Chevrolet 2500 C/K (2000-2006)
Chevrolet 3500 C/K (2000-2006)
Chevrolet Silverado (1999-2006)
Chevrolet Suburban (2000-2006) Chevrolet Tahoe (2000-2006)
GMC Sierra Truck (2000-2006)
GMC Yukon (2000-2006)
Complete Vehicle Mount
RAM-VB-102-SW1
National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 8410 Dallas Ave S
Seattle, WA 98108
Website: www.ram-mount.com
Email: [email protected]
Vehicle base for the
INSTALLATION INSTRUCTIONS
1. Remove the two front 5/16" hex nuts that hold the passenger side seat cushion to the seat track brackets.
2. Lift the front of the seat cushion off of the front of the the seat track brackets.
3. Position the VB-102 on top of the seat track brackets so the slots in the VB-102 line up with the holes in the seat track
brackets.
4. Lower the seat cushion back into place, allowing the studs to pass through the holes in the VB-102 and seat track
brackets.
5. Re-attach the two 5/16" hex nuts.
Optional Lever Stop Installation:
1. After mounting the vehicle base under seat, place seat in desired permanent position.
2. Attach the level stop plate onto the main seat base plate with the provided bolts. The lever stop plate should cover the
seat lever after installation. This item is recommended to be installed though optional.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-102 & RAM-VB-102-SW1
Chevrolet 2500 C/K (2000-2006)
Chevrolet 3500 C/K (2000-2006)
Chevrolet Silverado (1999-2006)
Chevrolet Suburban (2000-2006) Chevrolet Tahoe (2000-2006)
GMC Sierra Truck (2000-2006)
GMC Yukon (2000-2006)