RAM Mount RAM-VB-104-SW1 - Manual

This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
Vehicle base for the
SPECIFICATIONS
Placement
Passenger side on the floor, in front of seat
Drilling Required
No - uses existing seat bolts
Seat Configuration
Bucket/Bench
Construction/Finish
Steel/Black Powdercoat
Dimensions
Pole or Pedestal
Ordered Separately
Weight
10.7 lbs.
Tools required for base installation
15mm socket, 15mm box end wrench. Tools for
complete system assembly: pliers, phillips screw
driver, #10, ½”,
9/16” box end wrench’s.
A = 16", B = 5", C = 5.5”
Hole Center = 13”
Notes.
This base will not interfere with factory installed console or 4WD
lever. One 4” riser is included with this vehicle base. Riser allows
optimized placement of mount with a minimal amount of intrusion of
passenger leg space. This base will not fit trucks with power take-
off (PTO) on the transmission. If your vehicle has the PTO
accessory on the transmission, you will need the RAM-VB-178.
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-104 & RAM-VB-104-SW1
RAM-VB-104, SHOWN WITH
RAM-VB-SB4 RISER (INCLUDED)
Dodge Ram 1500 (2002-2008)
Dodge Ram 2500/3500 (2003-2008)
National Products, Inc.
Website: www.ram-mount.com
Email: [email protected]
8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615
National Products, Inc.
Website: www.ram-mount.com
Email: [email protected]
8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615
Complete Vehicle Mount
RAM-VB-104-SW1
Vehicle base for the
INSTALLATION INSTRUCTIONS
1.
½” box end wrench is used to tighten the nuts as part of the riser hardware.
2. Move the passenger seat to the rearmost setting.
3. Remove the front seat rail bolts that fasten the passenger seat brackets to the vehicle floor. Use the 15mm socket to
remove the seat leg bolts holding the passenger side seat frame to the floor board.
4. Without moving the seat, place the base over the front of the seat legs and align the holes in the base and legs.
5. Re-install the seat bolts starting the thread by hand. After the bolts have been started, use the 15mm socket and
torque bolts to 39 ft lbs.
Note: It may be necessary to put the inside seat bolt through the No-Drill™ base prior to a attaching the riser. Once
assembled, place the no drill base over the seat frame leg holes and start the inside bolt by hand, then the outer seat
bolt by hand. Use a box end wrench to fully tighten the inside bolt and a socket for the outer seat bolt.
If using the riser, attach the RAM-VB-SB4 riser to base with the provided carriage bolts, washers, and nuts. The
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-104 & RAM-VB-104-SW1
Dodge Ram 1500 (2002-2008)
Dodge Ram 2500/3500 (2003-2008)