RAM Mount RAM-VB-158-SW1 - Manual (Page 2)

National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: [email protected]
Vehicle base for the
INSTALLATION INSTRUCTIONS
1. Move seat to its rear most position.
2, Using a wrench, loosen and remove the two front seat leg bolts holding the seat frame to the floor board.
3. Place the no drill base over the seat frame legs and align the holes.
4. Replace the seat leg bolts starting the thread by hand so as not to cross thread the bolts.
5. Using a wrench, fully tighten the seat leg bolts.
After a week of road use or a day of off road use, check seat leg bolts and re-tighten if necessary.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-158
JEEP WRANGLER (1997-2006)